Magnum Reels

6 Wire Remote Reel

$949.00 USD

All Sizes in stock

 --------------------------------------------------------------------------------------

 

The 6 wire electric extension and remote reel offers best in the business connectivity.

The 6 wire reel uses a wind turbine potted rotary unit with Teflon 14 gauge wiring in a completely weather sealed unit.  The Contacts are maintenance free!  That means no more bad connection days for you. The 6 wire reel does not include a lead to the welder, instead the endcap is removed and there is a color coded harness to attach your wires to. To connect your spool lead, slide out the rotary from the center of the shaft and feed your cable in through the shaft and connect the color coded wires.

High Grade 6061-T6 Aluminum Construction

Cold Weather Safe, tested to work in -25C (-13F) weather.

The wire can be used for your electrical cord and a remote control 

Capacity - The rotary is re purposed from a wind turbine, we use the same rotary in all the 4-6 wire reels and they are rated to run 20-Amps with less than one milliohm of resistance. The 6 wire reel comes with 16awg wire soldered on.

Continuous electric connections in both winding and unwinding

Easy wire hook up

The reel is fully sealed. The bearings and rotary parts reside inside a sealed housing. The bearings, each rated to over 6,500lbs dynamic load and filled with a wide temperature low friction grease reside inside this housing.We use a heavy duty lip seal to seal the shaft to the base and o-rings to seal the other components which keeps that grinder dust and other elements out of your reels!  This makes them cold and hot weather safe and keeps them running in all sorts of extreme conditions.

The finish on the parts is hard anodizing which increases surface hardness by ~ 4x and is applied in a controlled thickness which means we can coat everything, even the threaded holes. This prevents the galvanic corrosion that naturally occurs when aluminum and stainless meet.  All aluminum used in the construction of the reels is 6061-T6 and is North American aluminum.

Our reels are built by pipeline welders and can withstand the harshest conditions, tried and tested.  This is also one of the reasons we have custom created a twin bearing easy grip handle to make the last job of the day a little easier. 

Interchangeable end plates for increased hose capacity (sold Separately)

 

Cable Capacity:

10.2" end plates:  100' of 6-12 with lock

13.7" end plates:  200-250 of 6-12 with lock

 

Mounting Instructions:

https://magnumreels.com/pages/mounting-instructions

 

To connect your spool of cable to the reel remove the 5 fasteners on the shaft and remove the 5 on the end cap. Slide the rotary connector out of shaft, there is room to gently pry it out once the end cap is removed. Feed your spool wire through the second shaft and through the cable gland through the main shaft and out. Connect these wires to the non-spinning side of the rotary color coded wires using desired method (we recommend solder and heat shrink with glue). Slide rotary back into main shaft and then tighten down the cable gland. Slide second shaft assembly onto the main shaft and align with hash marks. re-install the 5 fasteners and begin to wrap the cable up to the strain relief. If you have already connected the reel to your machine you are ready to go.

To connect the reel to your machine, with the end cap of the reel off, feed the cable through the end cap and cable gland. Connect cable to color coded wires and re-install the end cap with the cable gland facing the desired orientation. Tighten down the cable gland, soap on the cable jacket makes it easier to slide the grommet. 

You may also like

Recently viewed